MPI-520 – USER MANUAL
CABLE 5: R
ISO
(L1-L3),
R
ISO
(L2-L3),
R
ISO
(L2-PE),
U
ISO
, [LIMIT I], [NOISE]
U
ISO
, [LIMIT I], [NOISE]
U
ISO
, [LIMIT I], [NOISE]
Remarks:
- While viewing the memory, empty measurements and memory banks are not accessible. “Measure-
ment 1/20” signifies the first of the 20 measurements; measurements 21…99 are empty and inaccessi-
ble. The same principle applies to memory banks. If the memory is stored in a non-continuous manner,
empty measurements and memory banks are omitted while the memory is being viewed.
4.3 Deleting memory data
Set the rotary switch of function selection
at MEM position.
Select “Memory erasing” by means of
and push-buttons.