Sonic SCS-60 - Page 61

6-11
INPUT TIMING
Description
Manual
The set mark “ ” is displayed in the cross-cursor position at
the time of pressing the setting key ( ) and also is
displayed on multiple screens. Each time the setting key ( )
is pressed, the multiple screens are renewed.
1/1
The multiple screens of areas with the set mark “ ” is
renewed for each transmission of the areas.
1/2
1/4
1/8
These are to determine transmission times of areas with the
set mark “ ” when the multiple screens of the areas are
renewed.
For example, if "1/2" is set, the sub screen of an area with the
set mark “ ” is renewed once every two transmissions.