7-10
Important:
When removing the CB561 cable coating at your site, cut away about 10 mm of wire
coating. Any exposed wire length that is not cut away by about 10 mm may cause a
contact error or malfunction.
Figure: CB561 terminal processing
7.2.3 Automatic ascending
An automatic ascending circuit for the transducer is installed in this system.
When the transducer is projected (at the lower limit), pressing the OFF key ( ) of the
controller activates the automatic ascending of the transducer. After the transducer is
housed at the fixed position, the power is OFF. For ensuring safety, please be sure to
perform maintenance after shifting the AUTO/MANUAL selecting switch to the
“MANUAL” position, in order to disable this automatic ascending.
To Next Page
Loading...