8-1
Chapter 8 Connecting a mouse/trackball
The processor of this sonar system is provided with a connector for the use of
commercially supplied mice/trackballs. With a mouse/trackball connected to the processor,
unique operation not available with the RC-25 is allowed.
A mouse/trackball can be connected to the USB port on the connector panel of the
processor.
Note: A mouse/trackball that is prepared by yourself can be connected to
the processor. However, if the place where the mouse/trackball is
operated is distant from the place where the processor is installed,
additional wiring is required. In such a case, please contact one of
our service representatives for consultation.
Connector panel of processor
To Next Page
Loading...