8-4
8.2 Event display
The event display function is available using the RC-25 controller. However,
connecting a mouse/trackball to the processor allows for event display not only from
the RC-25 controller but also by using the wheel of the mouse/trackball.
8.2.1 Setting method
As the operation of a mouse/trackball is enabled only when the mouse/trackball is
connected to the processor, the mouse/trackball operation is disabled when the
system is shipped. The mouse/trackball operation needs to be enabled when used,
through the menu.
Procedure for enabling wheel event display
(1) Move the cross-cursor to the bottom of the screen, and then press the menu key
( ) to open "OPTION.”
(2) Place the cross-cursor over "BASIC OPTION" in the "OPTION” menu, and then
press the RC-25 menu key ( ) to open the "BASIC OPTION" menu.
(3) Place the cross-cursor over "MOUSE/TRACKBALL" in the "BASIC OPTION" menu,
and then press the RC-25 menu key ( ) to open the "MOUSE/TRACKBALL"
menu.
(4) Place the cross-cursor over "BUTTON" in the "MOUSE/TRACKBALL" menu, and
then press the RC-25 menu key ( ) to open the "BUTTON" menu.
(5) Place the cross-cursor over "EVENT" in the "BUTTON" menu, and then press the
RC-25 menu key ( ). Then, event display using the wheel is enabled.
To Next Page
Loading...
General