6-13
This is for setting the tilt manually.
This is for changing the tilt automatically each time the
transmission is performed by an angle set using the auto tilt mode.
For example, when the tilt is 0°, and 2° is set for the auto tilt mode,
the tilt is continually changed each time the transmission is
performed, in the order of −2° → −4° → −2° → 0° → +2° → 0°.
Unlike the continual change in the auto tilt mode, the oneshot
mode is for performing only one cycle of the auto tilt mode.
For example, when the tilt is 0°, and 2° is set for the auto tilt mode,
the oneshot mode performs only one cycle of the tilt changes for
each transmission, in the order of −2° → −4° → −2° → 0° → +2° →
0°, and it ends the operation.
This is used with the event mark for automatically changing
the tilt to track the depth of the event mark .
The tilt cannot be changed while tracking.
To Next Page
Loading...