The markers are displayed when the mode dial is set to (Movie/S&Q Motion) or when shooting
movies.
You cannot display markers when using [Focus Magnifier].
The markers are displayed on the monitor or viewfinder. (You cannot output the markers.)
[350] List of MENU items Camera Settings2
Marker Settings (movie)
Sets the markers to be displayed while shooting movies.
Menu item details
Center:
Sets whether or not to display the center marker in the center of the shooting screen.
[Off]/[On]
Aspect:
Sets the aspect marker display.
[Off]/[4:3]/[13:9]/[14:9]/[15:9]/[1.66:1]/[1.85:1]/[2.35:1]
Safety Zone:
Sets the safety zone display. This becomes the standard range that can be received by a
general household TV.
[Off]/[80%]/[90%]
Guideframe:
Sets whether or not to display the guide frame. You can verify whether the subject is level or
perpendicular to the ground.
[Off]/[On]
Hint
You can display several markers at the same time.
Place the subject on the cross point of the [Guideframe] to make a balanced composition.
[351] List of MENU items Camera Settings2
MENU → (Camera Settings2) → [ Marker Settings] → desired setting.
1
To Next Page
Loading...
