[412] List of MENU items Setup
NTSC/PAL Selector
Plays back movies recorded with the product on a NTSC/PAL system TV.
Note
If you insert a memory card that has previously been formatted with a different video system, a
message telling you that you must reformat the card will appear.
If you want to record using another system, re-format the memory card or use another memory card.
When you perform [NTSC/PAL Selector], and the setting is changed from the default one, a
message "Running on NTSC." or "Running on PAL." will appear on the start-up screen.
[413] List of MENU items Setup
Cleaning Mode
If dust or debris gets inside the camera and adheres to the surface of the image sensor (the part
that converts the light to an electric signal), it may appear as dark spots on the image,
depending on the shooting environment. If this happens, follow the steps below to clean the
image sensor.
MENU →
(Setup) → [NTSC/PAL Selector] → [Enter]
1
Confirm that the battery has been charged sufficiently.
1
MENU →
(Setup) → [Cleaning Mode] → [Enter].
The image sensor vibrates a little to shake off the dust.
2
Turn off the product following the instructions on the screen.
3
To Next Page
Loading...
