Sony CMT-DF1 - Recording to Connected Components

36
GB
1 Connect a digital optical cord.
See “Hooking up optional components”
(page 34).
2 Press DVD (or FUNCTION + or –
repeatedly) to switch the function to
DVD.
Playback starts automatically if a disc with
auto playback function is loaded. Press x to
stop playback. To cancel Resume Play,
press x twice.
3 Start recording with the connected
digital component (MD deck, etc.).
Refer to the operating instructions provided
with the connected component.
4 Press H (or NX on the unit) to start
playing.
Notes
• You cannot make a digital recording in the following
cases.
– Copy guarded DVDs
– DVD Dolby Digital or DTS bit stream output
– CD-Rs/CD-RWs recorded in music CD format
• You cannot make a recording when “SPDIF Output”
under “SPDIF Setup” in “Audio Setup Page” is set to
“SPDIF Off.”
Recording on a connected
component