40
GB
A stereo FM program cannot be received in
stereo.
• Press FM MODE repeatedly until “MONO”
disappears.
Tape deck
The tape does not record or play, or there is a
decrease in sound level.
• The heads are dirty. Clean them (page 43).
• The record/playback heads are magnetized.
Demagnetize them (page 43).
The tape does not erase completely.
• The record/playback heads are magnetized.
Demagnetize them (page 43).
There is excessive wow or flutter, or the sound
drops out.
• The capstans or pinch rollers are dirty. Clean them
(page 43).
Noise increases or the high frequencies are
erased.
• The record/playback heads are magnetized.
Demagnetize them (page 43).
The tape does not record.
• No cassette is loaded. Load a cassette.
• The tab has been removed from the cassette.
Cover the broken tab with adhesive tape
(page 43).
• The tape has wound to the end.
Optional components
There is no sound.
• Refer to General item “There is no sound.”
(page 37) and check the condition of the system.
• Connect the component properly (page 34) while
checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all the way.
• Turn on the connected component.
• Refer to the operating instructions supplied with
the connected component and start playing.
If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
Use buttons on the unit for the operation.
1 Remove the disc if it is loaded.
2 Press POWER to turn off the system.
3 Hold down DISPLAY and VOLUME +, and
press POWER.
Release the buttons as soon as the system turns
on.
4 Wait until “FM 87.50 MHz” appears.
The system is reset to the factory settings except
for DVD settings. You should set the settings
you made, such as the preset stations.
To return the settings to the
default settings*, perform reset
as follows:
The operation can only be set using the TV
screen.
1 Remove the disc if it is loaded.
2 Press SETUP.
3 Press < or , repeatedly to select
“Preference Page,” then press ENTER.
4 Press M or m repeatedly to select “Default,”
then press ENTER.
“Reset” is selected.
5 Press ENTER.
It takes a few seconds to complete. Do not press
?/1 when resetting the system.
* Except for Parental Control settings
To Next Page
Loading...
Need help?
General
Weight and Dimensions
