Sony CX-JTD8 - Page 87

87
CX-JTD8
Pin No. Pin Name I/O Description
46 I-BASS ON/OFF O
I-BASS on/off control signal output terminal
47 TBL-POS O Table motor drive signal (clockwise) output terminal
48 TBL-NEG O Table motor drive signal (counterclockwise) output terminal
49 LOD-POS O Loding motor drive signal output (load-out direction)
50 LOD-NEG O Loding motor drive signal output (load-in direction)
51 to 53
ENCODER-SW1 to
ENCODER-SW3
I Rotary encoder pulse input from the CD/DVD mechanism deck section
54 EJECT-SW I
Detection input from the tray open/close detect switch
“L”: when tray is close, “H”: when tray is open
55 T-SENS I CD/DVD table address detection signal input terminal
56 HP-SW I
Connection detection signal input of the headphone jack
“L”: no connected, “H”: headphone connected
57 MIC-SW I
Connection detection signal input of the microphone jack
“L”: no connected, “H”: headphone connected
58 A-TRG O
Deck-A side trigger plunger drive signal output “H”: plunger on
59 B-TRG O
Deck-B side trigger plunger drive signal output “H”: plunger on
60 A-SHUT-IN I
Shut off detection signal input from the deck-A side reel pulse detector
61 B-SHUT-IN I
Shut off detection signal input from the deck-B side reel pulse detector
62 VCC — Power supply terminal (+3.3V)
63 SWFR-MUTE O Muting on/off control signal output “L”: muting (sub woofer)
64 VSS — Ground terminal
65 CAPM-CONT O Capstan motor drive signal output “H”: active
66 B-RECFWD O
Detection input from the deck-B record detect switch (forward direction)
67 B-RECREV O
Detection input from the deck-B record detect switch (reverse direction)
68 A-HALF I
Detection input from the deck-A cassette detect switch “L”: cassette in, “H”: no cassette
69 B-HALF I
Detection input from the deck-B cassette detect switch “L”: cassette in, “H”: no cassette
70 A-PLAY I
Detection input from the deck-A play detect switch “H”: deck-A play
71 B-PLAY I
Detection input from the deck-B play detect switch “H”: deck-B play
72 AMS-IN I
Automatic music sensor detection signal input terminal
73 DISPLAY-KEY I Display key input terminal (A/D input)
74 POWER-KEY I Power key input terminal (A/D input)
75 M-RESET O System reset signal output to the front panel controller
76 STANDBY-LED O LED drive signal output of the standby indicator “L”: LED on
77 BIAS O
Recording bias on/off control signal output “H”: bias on
78 PB-A/B O
Deck-A/B selection signal output “H”: deck-A, “L”: deck-B
79 TC-RELAY O
Recording/playback select signal output to the REC/PB switch “L”: recording
80 PB-MUTE O
Playing muting on/off control signal output terminal “L”: muting on
81 REC-MUTE O
Recording muting on/off control signal output terminal “L”: muting on
82 FAN-CONTROL
O Fan motor drive signal output “H”: active
83
LINEOUT-MUTE
OMuting on/off control signal output “L”: muting (line out (MD/VIDEO))
84 LINE-MUTE O line muting on/off control signal output “L”: muting
85 STK-MUTE O
Power amplifier on/off selection signal output terminal “L”: muting
86 PROTECT I
Protect on/off signal input terminal “L”: protect
87 STB-RELAY O
Main power on/off relay drive signal output terminal “H”: power on
88 FRONT-RELAY O
Front speaker on/off relay drive signal output terminal “H”: front speaker on
89 REAR-RELAY O
Rear and center speakers on/off relay drive signal output terminal
“H”: rear and center speakers on