|
Adding effects to an image
To cancel the editorial operations in the EFFECT menu
Select "RESET" in the main EFFECT menu and then press ENTER. The
confirmation dialog box for cancelling editions is displayed. Press the arrow
(*/*) button to select "OK" and then press ENTER.
To exit the EFFECT menu screen
Select "EXIT" in the main EFFECT menu and then press ENTER. The
confirmation dialog box for exiting the EFFECT menu is displayed. Press the
arrow (_-/*) button to select "OK" and then press ENTER. The EFFECT menu
bar disappears.
To redo operations midway
Press CANCEL. The screen of the preceding procedure appears.
To display another sub menu
Press t_ until the current sub menu disappears.
To print an image
Press PRINT. The print dialog box is displayed. To increase the print
quantity, press ENTER. To reset it, press CANCEL. Then press the arrow (_-/
*/,I./t) buttons to select "OK" and press ENTER. The image being displayed
will be printed.
To save the edited image
Select "SAVE" in the main EFFECT menu and then press ENTER. The
confirmation dialog box for saving an image is displayed. Press the arrow (*/
*) button to select "OK" and then press ENTER. The edited, adjusted, or
processed image is saved on the "Memory Stick".
m
• If the "Memory Stick" is in write protect status, you cannot save an imago in the
"Memory Stick".
• While saving the image, do not turn off the power or remove the "Memory Stick"
from the printer. The "Memory Stick" may be damagod.
• It may take longer to process an edited image after you press the PRINT button.
• Do not remove the "Memory Stick" while in the EFFECT mode. If you do, the
EFFECT mode ends forcibly and any editing you have done is canceled.
• If an extremely oblong imago is edited, margins may appear in the upper or bottom
parts of the imago.
28 GB
To Next Page
Loading...
