Sony DXC-637 - Lens Iris Control and Adjustment; Lens Iris Adjustments; Macrophotography

92-1
(4a)dze9-OXxa
(on)ze9-Oxa
The background is very bright, and the
subject is too dark.
Settings for special cases
Press the AUTO IRIS (BACK L) button,
turning the indicator on.
The subject is under a spotlight.
Press the AUTO IRIS (SPOT L) button,
turning the indicator on.
This lightens the foreground.
This prevents white burn-out in
highlights of faces and clothes.
cen
The subject is completely still (e.g.
when shooting documents, drawings,
etc.).
When you wish to give a lush effect, as
when shooting a wedding or similar
occasion.
Shooting under fluorescent lighting.
To use white burn-out as a special
etfect. (For example, shooting against
the light in a desert scene of a person
walking.)
To make focusing before shooting
easier.
To begin shooting immediately when
there is no time to make adjustments.
Enable the EVS (Enhanced Vertical
definition System) function. (See page
41)
Enabling the EVS function tends to
increase the occurrence of aliasing
problems (moiré patterns). Therefore,
normaly leave the function disabled.
Move the MATRIX switch to the H. SAT
position.
Move the MATAIX switch to the FL
position.
Move the OUTPUT/DCC switch to the
CAMI/DCC OFF position.
Press the EZ FOCUS button, turning the
“easy focus” function on.
Set the EZ MODE switch to the ON
position.
This enhances the vertical resolution.
This increases the saturation of primary
colors.
This eliminates the blue-green cast,
and restores natural hues.
This allows overexposure, so that the
background appears all-white.
This opens the iris, to make it easier to
focus before beginning shooting.
This provides automatic adjustment to a
set of standard values, to allow
immediate shooting.
ni
Mey aallaye ave ltershicey ats)
BVV-5/SPS or similar VTR, the WARNING indicator
on the VTR also lights or flashes, and warning
indications appear in the display window. There is
also a warning tone in the earphone.
If a fault occurs during operation, a waming is given
by the REC/TALLY and BATT indicators in the
viewfinder and the tally lamp lighting or flashing, and
also by warning indications on the viewfinder screen.
When you are using an EV V-9000/9000P, PV V-3/3P,
Warning indications
The video |The VTRemits a | Carry out head cleaning,
heads are | warning tone when | referring to the
clogged, or | it detects head instruction manual for
RF (during there is clogging. the VTA. ff the problem
ser
_
recording
oO:
weve
some
other
persists
after
cleaning
4 only) (During fault in the the heads, disconnect
recording onty) | "cording the power and consult
system. your Sony service
representative.
The servo | Recording Disconnect the power
jock has. continues, but the | and consult your Sony
been lost. | recording may not rahe ei ed
3 a eiare’s be satisfactory. (The SERVO indication
set = _ wx SERVO ates may flash momentarily
when the tape transport
Starts, but this does not
indicate a problem.)
Oe ever There is Recording Stop the tape transport.
(During condensation continues, but if the | Wait until the HUMID
; ‘ Fecording) tape sticks to the _ | indication does not
ot _ = oS HUMID “(During pisead drum, recording appear when you power
; : playback stops. Playback, | the unit on.
fewind, or fast rewind, or fast
forward) forward stops.
7 | a
The tape is | The operation Press the EJECT button
not wound | stops. (Refer to the} to eject the cassette.
properly. service manual or | Close the cassette
maintenance compartment and check
manual.) that the top panel has.
- - Jee | SLACK descended before
powering oft. Then
consult your Sony
service representative.
(Do not attempt to insert
any cassette.)
TAPE The tape is | Operation Change the cassette if
flashing, near the continues, necessary.
we] — | — [ibang iting’ feweine Fong
only} recording only)
; hi TAPE Hs fape is Recording, Change the cassette.
Sey
a
—
Dire
5
a
at
the
end.
|
playback,
and
fast
x ‘ (flashing) forward alt stop.
t BATT BATT oni The battery | Operation Change the battery
* x 11.0V . 3 (flashing) {During is almost continues. when possible.
recording) exhausted,
BATT BATT The battery eration stops. Change the battery.
sem. | e fiosv at (llashing) etnies wis fis vA ” 8
i - exhausted.
ste
a ‘ a
>, Continuous 3K Flashing once per second Jee Flashing four times per second
For the warnings appearing in the viewfinder when a PVV-3/3P is connected, sec the section "Viewfinder Normal Indications” (page 35).