Sony DXC-637 - SW-724 and EN-122 Board Switches

AUTH
SW-724 board
° S11 (ADJ ON/OFF)
When set to “ON” (up side), the unit is put into ADJ mode, and
various adjustments can be performed.
This switch is factory-set to “OFF” (CN1 side).
[Procedures]
1. When $11 is set to “ON”, characters displayed on the VF
screen are all erased and the screen @) will be displayed.
(In clock setting, the screen @ will be displayed after
setting is complete.)
2. 1) While the screen © is displayed, by pressing the UP/
ON button on the front of camera, data in a memory
“EEPROM?” is preset as shown in the table and then
the screen @) is displayed. Next the screen @ is
displayed and the unit enters the ADJ mode.
PRESET VALUES
Adjusted value is preset
djusted value is preset
Setting value is preset
Setting value is preset
|MPED —_—_| Setting value is preset
1/100 (NTSC), 1/60 (PAL)
ote dB
ITEMS
(ADVANCED MENU)
ENTISO%
0%
MiPTE
1
>
PRESET VALUES
O}H| | w x a = m1 S)
OFF
2) While the screen @ is displayed, press down the
DISP CHG switch. The screen @) will be displayed
and the unit enters the ADJ mode.
wo
_
~—
While the screen @) is displayed, by pressing the UP/
ON or DOWN/OFF button, data value will be varied
from 00h to FFh.
While the screen @ is displayed, by pressing both the
UP/ON and DOWN/OFF buttons simultaneously, data
value show “80h”.
2
~—
4. By using the DISP/CHG switch, adjustment items is
changed from 01h to 18h.
[Adjustment items]
01 GDARK 09 BSHADBAL 11 RVAGAIN
02 GBLACK1 0A GH SAW 12 BVA GAIN
03 R DARK 0B RH SAW 13 M PRE KNEE
04 RBLACK1 0C BH SAW 14 R PRE KNEE
05 BDARK oD GV SAW 15 BPRE KNEE
06 BBLACK1 0o—& RV SAW 16 ZEBRA (70%)
07 GSHAD BAL OF BV SAW 17 ZEBRA (100%)
08 RSHADBAL 10 GVAGAIN 18 MICLEVEL
VF screen
ADJ
UP:ERASE
DISP:NEXT
ERASE OK
01GDARK : 80
Adjustment Data
items value
DXF-637 (UC)
DXF-637P (EK)