Other Information
39
To delete abnormal data from the built-in flash memory
If “CANNOT PLAY,” “EXPIRED,” “FILE ERROR,” or “MG ERROR” is displayed, there is a
problem with all or part of the data stored in the built-in flash memory.
Please follow the procedures below to erase data you cannot play.
1 Connect your Network Walkman to the computer, and start the SonicStage software.
2 If you have already specified the data with problems, erase the data from the Portable Player
window of the SonicStage software.
3 If the problem persists, transfer all data without problems back to the computer using the
SonicStage software while your Network Walkman is connected to the computer.
4 Disconnect your Network Walkman from the computer and then format the built-in flash
memory using the FORMAT menu (page 32).
Message
NO DATA
USB CONNECT
Meaning
There are no audio files in the
built-in flash memory.
Your Network Walkman is
connected to the computer.
Remedy
If there are no audio files in the built-in
flash memory, use the SonicStage
software to transfer audio files.
You can operate your Network Walkman
using the SonicStage, but you cannot
operate the controls on your Network
Walkman.
To Next Page
Loading...
