Sony EV-S900 - Handling Recording Issues

When ihe: recording: is meds to to the end of the:
tape during recdrding ° :
The tape will be gistornatioalty jewound to ‘the Secinning
and the unit will enter the stop mode. The power
remains on.
To. make a frame-by-frame recording
To tape an animated program, proceed as follows:
Press @ REC buttons on the Commander or slide @
REC to the right on the VCR while the unit is in
recording pause mode. A very short recording of
approximately 7 or 8 frames will be made and then the
VCR will automatically enter recording pause mode
again. Repeat this operation as many times as you like,
To watch one TV program while recording another
Press TV/VTR so that the VTR indicator goes off. Select
the channel you want to watch on the TV.
If your TV is equipped with a TV/VTR input selector, simply
set the selector to TV and select the desired channe} on
the TV.
If the cassette is ejected when the @ REC buttons are
pressed
The tab on the cassette is slid out. Slide the tab in or use
a new cassette.
If a stereo program is noisy
Set AUTO STEREO to OFF. The noise will be reduced
though the sound is heard in monaural.
{f you started recording of an unnecessary scene
You can return the tape to the desired point and set the
VCR to recording standby mode.
1 Press m STOP to stop recording.
2 Press ® PLAY and then press f1/pi<@ to set the VCR to
playback pause mode.
3 Locate the desired point where you wish té start
recording by turning the JOG dial counterciockwise.
4 Press the @ REC buttons. The VCR will enter recording
pause, mode.
5 At the desired point, press tl/Pid EpUsHoul to
release pause mode.
Recording will begin.
19