7
GB
GB
Front Panel
Location and Function of Parts and Controls
1 MENU (page 20)
2 / (INPUT)
• In the menu screen, this button works as the “Set”
button.
• This button switches the input signal when it is not
in the menu screen.
Selects an input signal from among the HD15/
HDMI 1/HDMI 2/OPTION 1/OPTION 2
connectors.
When an optional adaptor is not installed in the
OPTION 1/OPTION 2 slot, OPTION 1/OPTION 2
will be skipped.
3 /
• In the menu screen, these buttons work as left/right
buttons.
• In the “PAP” mode, these buttons work to change
the active picture or change the picture size when a
screen other than the menu screen is displayed.
4 //
• Increases (+) or decreases (−) the volume.
• In the menu screen, these buttons work as up/down
buttons ( / ).
5 1
Switches the display on or off (standby).
To protect the panel, a certain amount of time is
required to turn the display to on/off (standby). When
you turn the display on again, soon after turning it off,
wait about 5 seconds before you turn it on again.
6 Sony logo
The Sony logo lights up.
You can switch “On”/”Off” in the menu screen.
See “Advanced Setup” on page 30.
7 Remote control sensor
8 POWER/STANDBY indicator
• Lights up in green when the display is switched on.
• Lights up in red when the display is in standby
mode.
• Lights up in orange when the display enters the
power saving mode when the current input is not
video or S Video.
When the “LED” option in the “Multi Display”
settings is set to “Off” and the “Position” option is not
set to the right-bottom, the indicator does not light up
in green even when the display is turned on, except for
the case of no signal or an unsupported signal.
Note
Note
To Next Page
Loading...
Need help?
General