15
GB
GB
Using the PAP Setting
You can show two pictures from different signal
sources, such as a PC and a video, side by side.
You can also swap the left/right pictures, or change
the balance of left/right picture sizes.
Tip
You can also access the “PAP Setting” in the “Screen”
settings. See page 26.
The width of A and B is the
same.
The height will be set to
match each picture’s
aspect ratio.
Press g button.
The width of B is larger
than that of A.
If B’s aspect ratio is 4:3,
its height will be equal to
the panel size.
The width of A and B is
the same.
The height will be set to
match each picture’s
aspect ratio.
Press G button.
The width of A is larger
than that of B.
If A’s aspect ratio is
4:3, its height will be
equal to the panel size.
Press g button.
B on the right side
becomes the active
picture.
Cursor showing active picture
Press g button.
Available combination of two pictures
HD15 HDMI 1 HDMI 2 OPTION 1 & 2
RGB Component HDMI/
DVI
HDMI/
DVI
RGB Component Video S Video
HD15 RGB
aa
Component aa
HDMI 1 HDMI/DVI aa aaaa
HDMI 2 HDMI/DVI aa
aaaa
OPTION
1 & 2
RGB aa
Component aa
Video aa
S Video aa
To Next Page
Loading...
