EasyManua.ls Logo

Sony FWD-32LX2F Operating Instructions (Base Model) - Optional Adaptors

Sony FWD-32LX2F Operating Instructions (Base Model)
255 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
GB
Optional Adaptors
The connectors marked with 5 and 7 on the side
panel are slot-in types and can be fitted with any of the
following optional adaptors (not supplied).
For details on installation, consult your Sony dealers.
VIDEO INPUT Adaptor BKM-FW10
This is the same as the optional adaptor preinstalled in
the 7 OPTION 2 slot. See page 8.
COMPONENT/RGB INPUT Adaptor BKM-
FW11
1 Y/G P
B
/C
B
/B P
R
/C
R
/R IN (BNC): Connects to
the analog RGB signal or component signal output
of a piece of video equipment or PC.
2 HD VD IN (BNC): Connects to the
synchronization signal output of a PC.
When inputting a component signal, be sure not to input sync
signals to the HD and VD connectors. If you do so, the
picture may not be displayed properly.
3 AUDIO (Stereo mini jack): Inputs an audio
signal. Connects to the audio output of a piece of
video equipment or PC.
RGB/COMPONENT ACTIVE THROUGH
Adaptor BKM-FW12
1 RGB/COMPONENT IN (D-sub 15-pin):
Connects to the component signal output or
analog RGB signal output of a piece of video
equipment or PC. For details on inputting a
component signal to the connector, see “Pin
assignment” on page 35.
When inputting a component signal, be sure not to input sync
signals to pins 13 and 14. If you do so, the picture may not be
displayed properly.
2 RGB/COMPONENT OUT (D-sub 15-pin):
Connects to the component signal input or analog
RGB signal input of a piece of video equipment or
PC.
3 AUDIO IN (Stereo mini jack):
Inputs an audio signal. Connects to the audio
signal output of a piece of video equipment or PC.
When the display is not connected to an AC power or is in
the standby mode, no signal is output from the RGB/
COMPONENT OUT.
NETWORK MANAGEMENT Adaptor BKM-FW32
For details, see the instruction manual of the BKM-
FW32.
STREAMING RECEIVER Adaptor BKM-FW50
For details, see the instruction manual of the BKM-
FW50.
When using a network cable for the BKM-FW32/50, be sure
to use a shielded cable to help prevent the radiation of
undesired radio waves. For details on the connection, see
each instruction manual.
For details on the optional adaptors for system
expansion, BKM-FW series, see each instruction
manual.
Note
AUDIO
VD HD P
R
/C
R
/R P
B
/C
B
/B Y/G
COMPONENT/RGB INPUT ADAPTOR
1
2
3
Note
Note
Note
AUDIO
IN
OUT IN
RGB/COMPONENT ACTIVE THROUGH
1
2
3

Table of Contents

Related product manuals