24
GB
Sound Settings
Tip
You can adjust the sound quality menus (“Treble” and “Bass”) when the “Sound Mode” is set to “Custom”.
When the speakers SS-SP40FW/32FW (not supplied)
are installed, you can set various “Sound” settings.
To highlight an option and to change settings, press
F/f/G/g.
Press to confirm the selection.
The “Sound” settings include the following options:
Sound Mode
“Dynamic”: Select to enhance treble and bass.
“Standard”: Flat setting.
“SRS WOW”: Provides a panoramic stereo audio image by producing deep and rich
bass tones and clear treble tones, enabling you to enjoy powerful sound effects like
those in a movie theater.
“Custom”: Allows you to store preferred settings.
Tips
• To change from one “Sound Mode” option to another, you can also use SOUND on the
remote control instead.
• The proprietary technologies of BBE Sound, Inc. are applied for “Dynamic” and “Standard”.
Sound Mode Reset
Resets the following settings; “Treble”, “Bass” and “Balance” to the default settings.
Treble
Adjust to increase or decrease higher-pitched sounds.
Bass
Adjust to increase or decrease lower-pitched sounds.
Balance
Adjust to emphasize left or right speaker balance.
Common Audio Sel.
“HD15”: Outputs audio from a piece of video equipment or PC connected to the
HD15 (RGB/COMPONENT IN) connector and the AUDIO (COMMON AUDIO
IN) connector.
“HDMI 1”/“HDMI 2”: Select to connect a piece of equipment using an HDMI cable
(not supplied) or an HDMI-to-DVI cable, and the corresponding audio cable at the
same time.
See page 8.
• When using an HDMI-to-DVI cable (not supplied), connect the audio cable to the AUDIO
(COMMON AUDIO IN) connector.
• When “HDMI 1”/“HDMI 2” is selected, digital audio is not output from the HDMI
connectors. When a piece of video equipment equipped with an HDMI connector is
connected to the HDMI 1/HDMI 2 connectors, set “Common Audio Sel.” to “HD15”.
(The default setting is “HD15”.)
Speaker Out
“On”: Enables sound to be emitted from the speakers.
“Off”: Disables sound to be emitted from the speakers.
When “Speaker Out” is set to “Off”, “Sound Mode”, “Sound Mode Reset”, “Treble”, “Bass”,
and “Balance” cannot be selected.
Sound
: Exit:
Back:
:
MENU
HDMI 1
Sel
Set
Sound Mode : Dynamic
Sound Mode Reset
Treble :
Bass :
Balance :
Center
Common Audio Sel. :
HD15
Speaker Out : On
Dynamic
Standard
SRS WOW
Custom
Notes
Note
To Next Page
Loading...
Need help?
General