Sony HCD-CP33 - HCD-CP33 Service Mode Operations; Panel Test Mode Entry; Tape Deck Aging Mode Procedure; CD Aging Mode Activation

19
SECTION 4
SERVICE MODE
Start
REC pause for 3 seconds
FWD REC
Fast forward
REV Play
REC pause for 3 seconds
REV REC
Rewind
FWD Play
Shut off
Shut off
Shut off
Shut off
1 minute
3 minutes
1 minute
3 minutes
Start
Open the disc tray
Close the disc tray
Play the last track
[Panel Test Mode]
Procedure:
1. Set to standby state.
2. Press three buttons of PLAY MODE DIRECTION , CD x ,
and DSG simultaneously.
3. Liquid crystal display and LED are all turned on.
4. Pless MD Z to enter the version display mode. (destination,
MC, CD, ST, TC, TA, TM)
5. Press MD u to enter the KEY, VOL, check mode. ( m
. and M > must be pressed for several seconds.)
6. To exit from this mode, press the buttons in the same way as
step 2.
[Tape Deck Aging Mode]
This mode can be used for operation check of tape deck section.
Procedure:
1. Set a tape in the tape deck.
2. Set to standby state.
3. Press three buttons of TAPE x , CD x , (CD), and TAPE
simultaneously.
4. The aging is executed in bellow sequence.
5. To exit from the aging mode, press the ?/1 button to turn the
power OFF.
Aging mode sequence:
[CD Aging Mode]
This mode can be used for operation check of CD section.
Procedure:
1. Load a CD disc.
2. Set to standby state.
3. Press three buttons of TAPE x , CD x , and TUNER
simultaneously.
4. The aging is executed in bellow sequence.
5. To exit from the aging mode, press the ?/1 button to turn the
power OFF.
Aging mode sequence:
[Cold Reset]
Clears all the memories and starts up the machine again.
Procedure:
1. POWEWR ON state is in progress.
2. Press three buttons of CD x , PLAY MODE DIRECTION ,
and MD Z simultaneously.
[Hot Reset]
Starts up the machine again holding the memory data.
Procedure:
1. POWEWR ON state is in progress.
2. Press three buttons of CD x , PLAY MODE DIRECTION ,
and MD u simultaneously.