Sony HCD-EC709iP - Base Unit (BU-D1 BD73); Optical Pick-Up Block (DA11 MMVGP)

HCD-EC709iP/EC909iP
11
2-11. OPTICAL PICK-UP BLOCK (DA11MMVGP)
Note 1: When disconnecting the wire (fl at type) (16 core) of optical pick-up block, solder the short-land.
2-10. BASE UNIT (BU-D1BD73)
Note 1: This illustration sees the top panel block from base unit side.
1
four floating screws
(PTPWHM2.6)
4
two vibration proof rubbers
(red)
5
two vibration proof rubbers
(green)
6
four claws
2
stopper (D1)
7
cover (D1)
8
base unit
(BU-D1BD73)
3
(EC709iP)
Note 2: Four claws might be fixed by bond.
3
wire (flat type) (16 core) (optical pick-up)
1
Remove four solders.
2
Solder the short-land.
4
BD73 board block
7
optical pick-up block
(DA11MMVGP)
5
tapping screw (P2)
6
shaft (support)
Note 2: When assembling the optical pick-up block,
remove the solder of short-land after
connecting the wire (flat type) (16 core).