HCD-EX66/EX88/EX99
2
NOTES ON CHIP COMPONENT REPLACEMENT
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
FLEXIBLE CIRCUIT BOARD REPAIRING
• Keep the temperature of soldering iron around 270 °C during
repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
SAFETY-RELATED COMPONENT WARNING!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS
WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS
MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specifi ed herein may result in hazardous radia-
tion exposure.
This appliance is classifi ed as
a CLASS 1 LASER product.
This marking is located on the
rear exterior.
AM tuner section:
Tuning range
Latin American models:
530 kHz ‒ 1,710 kHz (10 kHz step)
531 kHz ‒ 1,710 kHz (9 kHz step)
Saudi Arabia model:
531 kHz ‒ 1,602 kHz (9 kHz step)
Other models:
531 kHz ‒ 1,602 kHz (9 kHz step)
530 kHz ‒ 1,610 kHz (10 kHz step)
Intermediate frequency: 400 kHz
General
Power requirements
Mexican model:
AC 127 V, 60 Hz
Argentine model:
AC 220 V ‒ 240 V, 50/60 Hz
Other models:
AC 120 V ‒ 240 V, 50/60 Hz
Power consumption
HCD-EX99: 85 W
(0.5 W at the Power Saving Mode)
HCD-EX88: 70 W
(0.5 W at the Power Saving Mode)
HCD-EX66: 45 W
(0.5 W at the Power Saving Mode)
Dimensions (W/H/D) (excl. speakers)
Approx. 210 mm × 312 mm ×
375 mm
Mass (excl. speakers)
HCD-EX99/EX88: Approx. 3.8 kg
HCD-EX66: Approx. 3.6 kg
Design and specifi cations are subject to
change without notice.
To Next Page
Loading...
