— 15 —
SW OSC Voltage Adjustment
(Tourist model)
Setting:
Band: SW
Procedure:
1. Connect digital Voltmeter to diode D1 center lead and ground.
2. Adjust for a following value reading on digital voltmeter.
Procedure:
Adjust for maximum reading on level meter.
Adjustment Location:
[TCB BOARD] — Component Side —
D1, CV2, T2
SW OSC Voltage
Adjustment
IC41
CV2
CV1
D1
T2
T1
TM1
CV1, T1
SW Tracking
Adjustment
Set frequency
1.2 ± 0.1 V
8.5 ± 0.2 V
5.95 MHz
17.9 MHz
T2
CV2
Reading on digital
voltmeter
Adjustment
part
SW
SW Tracking Adjustment
(Tourist model)
Setting:
Band: SW
AM RF SSG
set
level meter
SPEAKER terminal
AM ANTENNA terminal
30% amplitude
modulation by
400Hz signal
Set frequency
SW
7 MHz
17 MHz
T1
CV1
• Repeat the procedures is each adjustment several times, and the
frequency coverage and tracking adjustment should be finally done
by the trimmer capacitors.
Adjustment
part
To Next Page
Loading...
