37
US
C:\FY20HT_models\SB1\ANKI\UC2\01US-HTZ9FUC2\090SET.fm masterpage:
Right
HT-G700
5-013-058-11(1)
[BT]
(BLUETOOTH
settings)
[POWER]
(BLUETOOTH
Power)
You can turn the BLUETOOTH function on or off.
•[
ON]: Turns the BLUETOOTH function on.
• [OFF]: Turns the BLUETOOTH function off.
Note
When the BLUETOOTH function is set to off, the BLUETOOTH
input is skipped while selecting input by pressing INPUT.
[STANDBY] When the system has pairing information, you can turn the
system on and listen to music from a BLUETOOTH device,
even when the system is in standby mode, by setting the
BLUETOOTH standby mode to on.
•[
ON]: BLUETOOTH standby mode is enabled.
• [OFF]: BLUETOOTH standby mode is disabled.
Note
While the BLUETOOTH standby mode is on, standby power
consumption increases.
[AAC CODEC] You can enjoy high-quality sound if AAC is enabled and your
device supports AAC.
•[
ON]: Enables AAC codec.
• [OFF]: Disables AAC codec.
[SYSTEM]
(System
settings)
[IR REPEATER] • [ON]: Remote signals for the TV are sent from the rear of
the bar speaker.
•[
OFF]: Turns off the function.
For details, see “When the TV Remote Control does not
Work” (page 16).
[AUTO
STANDBY]
• [ON]: Turns on the auto standby function. When you do not
operate the system for about 20 minutes, the system
enters standby mode automatically.
•[
OFF]: Off.
•
[VERSION]
(Version
information)
The current firmware version information of the system
appears in the front panel display.
[RESET]
(Resetting the
system)
[ALL RESET] You can reset the system settings to the factory default. For
details, see “Resetting the system” (page 47).
Items Function
010COV.book Page 37 Wednesday, September 18, 2019 1:58 PM
To Next Page
Loading...
