xii
GB
About the
NEX-5T
Index
(NEX-5T)
Cannot connect the camera to a Smartphone using the One-touch function.
• Place the N mark on the Smartphone and the N mark on the camera as close as possible. If there is no
response, move the Smartphone a few millimeters or move the Smartphone away from the camera,
wait more than 10 seconds, and then touch them together again.
• If you cannot make a connection, do as the following:
– Launch “PlayMemories Mobile” on your Smartphone, and then move the Smartphone slowly
toward the N mark of the camera.
– If the Smartphone is in a case, remove it.
– If the camera is in a case, remove it.
• Make sure the strap isn’t covering the N mark on the camera when touching the Smartphone to the
camera.
• [Airplane Mode] is activated. Set [Airplane Mode] to [Off].
• When the camera plays back images in index mode, you cannot connect the camera and the
Smartphone with one touch.
• Check whether the NFC function is activated on your Smartphone. For details, refer to the instruction
manual of the Smartphone.
• Do not place any metal objects other than a Smartphone near the N mark.
• Do not contact two or more Smartphones to the camera at the same time.
• If another NFC-based application is running on your Smartphone, terminate that application.
Cannot download applications using the camera’s Wi-Fi.
• If the IP address of the camera is fixed, you cannot download applications using Wi-Fi. Select MENU
t [Setup] t [Access Point Settings] t access point to be connected, then set [IP Address Setting]
to [Auto]. Or connect the camera and the computer using a USB cable, and then download an
application via the computer.
To Next Page
Loading...
Need help?
General
