59
Changing the Angles
Playback
◆Night
Large sounds, such as explosions, are suppressed, but quieter
sounds are unaffected. This feature is useful when you want to
hear the dialogue and enjoy the surround sound effects of
“Wide” at low volume.
◆Standard
Creates three sets of virtual rear speakers from the sound of the
actual front speakers (L, R) as shown below.
This mode is effective when you use two separate front speakers.
To cancel the setting
Select “Off”.
z Hint
You can select the TVS mode from the TOOLS menu (page 61).
Notes
• When the playing signal does not contain a signal for the rear speakers,
the surround effects will be difficult to hear.
• When you select one of the surround modes, turn off the surround
setting of the connected TV or amplifier (receiver).
• Make sure that your listening position is between and at an equal
distance from your speakers, and that the speakers are located in
similar surroundings.
• Not all discs will respond to the “Night” function in the same way.
• The TVS function cannot be used with discs recorded on this recorder.
Changing the Angles
If various angles (multi-angles) for a scene are recorded on a
DVD VIDEO, “ANGLE” appears in the front panel display,
indicating that you can change the viewing angle.
Press ANGLE repeatedly during playback to
select an angle.
The scene changes to the selected angle.
Notes
• Depending on the DVD VIDEO, you may not be able to change the
angles even if multi-angles are recorded on the disc.
• You cannot change the angles when playing a disc recorded on this
recorder.
L: Front speaker (left)
R: Front speaker (right)
: Virtual speaker
L R
ANGLE
Angle 1(3)
To Next Page
Loading...
Need help?
General
