Dubbing/Editing
68
The starting point of the first program is set,
and the upper part of the program mark
changes to light blue.
7 Search for the end of the first scene
that you want to record on your
camcorder, then pause playback.
You can adjust the position with /
(frame).
8 Touch [MARK OUT].
The ending point of the first program is set,
and the lower part of the program mark
changes to light blue.
9 Repeat steps 5 to 8 and create
programs.
10Set your VCR to recording pause.
Skip this step if your camcorder is
connected via an i.LINK cable.
11Touch [START].
12Touch [EXEC].
A search for the beginning of the first
program starts, then the recording starts.
[SEARCH] appears during the search and
[EDITING] appears during editing.
When a program is recorded, the program
mark stops flashing and remains lit. When
all programs have been recorded, the
program editing operation stops
automatically.
To cancel recording, touch [CANCEL].
To end Digital program editing
Touch [ END].
To save a program without using it to
record
Touch [ END] in step 9.
The program is stored in memory until the
cassette is ejected.
To erase programs
1
Follow steps 1 to 4 in “Recording the
selected scenes as programs” (p. 67),
then touch [UNDO].
2 Touch [ERASE 1MARK] to delete the
last set program. Or, touch [ERASE
ALL] to delete all the programs.
3 Touch [EXEC].
The programs are deleted.
To cancel this operation, touch [CANCEL].
b Notes
• You cannot set the starting point or ending point on
a blank section of the tape. If there is a blank section,
the total time may not appear correctly.
• When you cannot operate the device correctly using
an i.LINK cable connection, select [IR] in step 9 on
page 64, and set the [IR SETUP] code.
ED I T
SET
UNDO
0:08:55:06
TOTAL
SCENE
0:00:00:00
0
V I DEO ED I T
MARK
OUT
START
END
ED I T
SET
UNDO
TOTAL
SCENE
0:00:13:00
1
V I DEO ED I T
MARK
I N
START
END
0:09:07:06
TOTAL
SCENE
0:00:01:29
3
V I DEO ED I T
END
CAN–
CEL
EXEC
START
ENGAGE
REC PAUSE
0:00:00:01
-
:
--
:
--
:
--
SCENE 1/3
V I DEO ED I T
END
CANCEL
SEARCH
To Next Page
Loading...
