Sony S-Frame DPF-D70 - Basic Operations; Power and Remote Control Setup

Basic operations
Preparing the remote
control
The supplied lithium battery (CR2025) has
already been inserted into the remote control.
Pull out the protective sheet before use as
shown in the figure.
Protective sheet
Using the remote control
Point the top end of the remote control towards
the remote sensor on the photo frame.
Remote
sensor
,~, .
0
0
r;::\
I?\
0::-)
1.,::../
1.:) ,0. 0
\,_.:- \::::..) ,
80
808
eGO
10 GB
Replacing the battery of the
remote control
If the remote control stops working. replace the
battery
(CR2025 lithium battery) with a new
one,
1 Pullout the battery holder.
While pressing in the tab of the battery
holder. pull out the battery holder.
2 Remove the old battery from the
battery holder and then insert a new
battery.
Insert the battery so that "+"' is facing
upwards.
, ,,~,j~)
~f'?
~
3 Reinsert the battery holder into the
remote control.
WARNING
Ballery may explode if mistreated. Do not
recharge. disassemble or dispose of in fire.
• When the lithium battery becomes weak. the
operati ng distance of the Remote con wi 111;1\
shorten. or the Relllote control may not run~·tion
properly. In this case. replace the battery \\'ith a
Sony CR202S lithium battery. Use of another
battery may present a risk of fire or explosion.