Sony SA-NS310 - Option 3-3: Manual Setting Method Using an Access Point Scan (for Iphone;Ipad;Ipod Touch)

18
GB
5 Tap
[Sony_Wireless_Audio_Setup]
on the network list.
6 Access the [Sony Network
Device Setting] screen.
Start the browser and input either of the
following URLs into the browser’s
address bar.
7 Repeat steps 5 to 9 of
“Option 3-1.”
After restarting the unit, confirm the
wireless settings of Android device
restore.
Note
Before starting this procedure, be aware that your
Wi-Fi network will not be protected until the setting
is complete. After the setting is complete, your Wi-
Fi network will be protected again when you set
wireless LAN security.
1 Turn the unit on.
Check that the ?/1 (ON/Standby)
indicator changes from flashing in green
to lit in green.
Notes
• If you have set this already, perform all-reset
for the unit.
• Do not connect the network (LAN) cable.
2 Tap [Settings] on the screen of
your iPhone/iPad/iPod touch.
Option 3-3: Manual setting
method using an Access Point
Scan (for iPhone/iPad/iPod
touch)