Using
the CONTROL
Al11
control system
Connect monaural (2P) mini-plug cables in series
to the CONTROL Al11 jacks on the back of each
component You can connect up to ten CONTROL
Al11 compatible components in any order
However, you can connect only one of each type of
component (i e , 1 CD player, 1 MD deck, 1 tape
deck and 1 receiver) (You may be able to connect
more than one CD player or MD deck, depending
on the model Refer to the operating instructions
supplied with the respective component for
details )
Example
Amplifier
CD player MD deck Other
component
In the CONTROL Al11 control system, the control
signals flow both ways, so there is no distinction of
IN and OUT jacks If a component has more than
one CONTROL Al11 jack, you can use either one,
or connect different components to each jack
About the connecting cable
When a CONTROL Al11 compatible component is
not supplied with a connecting cable, use a
commercially available monaural (2P) mini-plug
cable less than 2 meters (6 6 feet) long, with no
resistance (such as the Sony RR-G69HG)
(The monaural (2P) mini-plug cable is supplied for
Canadian models )
k
d
Automatic function selection
s
When you connect CONTROL Al11 compatible
5
Sony components using CONTROL Al11 cables
3
(not supplied), the function selector on the
i
amplifier (or receiver) automatically switches to
%
the correct input when you press the play button
-.
3
on one of the connected components
(For example, when you press D (play button) on
the CD while the MD deck is playing, the function
selector on the amplifier switches from MD to CD )
Notes
l
This function works only when the components are connected
to the amplifier (or receiver) inputs according to the names on
the function buttons Certain receivers allow you to switch the
names of the function buttons In this case, refer to the
operating instructions supplied with the receiver
l
When recording, do not play any components other than the
recording source It will cause the automatic function selection
to operate
Synchronized recording
This function lets you conduct synchronized recording
between the CD and the recording component
1
Set the source selector on the amplifier (or
receiver) to the CD.
2 Set the CD to playing pause mode (make sure both
the D and II indicators light together).
3 Set the recording component to recording pause
mode.
4 Press II on the recording component.
The CD is automatically released from pause mode,
and recording begins shortly thereafter
When play ends from the CD, recording stops
Tip
Certain recorder components may be equipped with a special
synchronized recording functions that uses the CONTROL A111
Control System; like “CD Synchro Dubbing ” In this case, refer to
the Operating Instructions supplied with the recorder
component
Note
Do not set more than one component to the pause mode
32”s
To Next Page
Loading...
