Getting Started
5
Getting Started
Step 2
Setting up the remote commander
Inserting the batteries
Insert two R6 (size AA) batteries by
matching the + and – on the batteries
to the diagram inside the battery
compartment.
Insert the negative (–) end first, then
push in and down until the positive
(+) end clicks into the position.
Using the remote commander
You can use this remote
commander to operate this
VCR and a Sony TV. Buttons on
the remote commander marked
with a dot (•) can be used to
operate your Sony TV.
Remote sensor
continued
Set [TV] / [VIDEO] to
[VIDEO] and point at the remote sensor on the VCR
[TV] and point at the remote sensor on the TV
To operate
the VCR
a Sony TV
[TV]/[VIDEO]
To Next Page
Loading...
