Sony SS-CTF500 - Page 32

SA-WSF200/WSF500/SS-CTF500/F500/TSF200/TSF500
32
Pin No. Pin Name I/O Description
64 VSS - Ground terminal
65 DC_DET I Over load detection signal input terminal
66, 67
DAMP_LATCH2,
DAMP_LATCH4
O Serial data latch pulse signal output terminal Not used
68 S-AIR_GPIO2 I Interrupt signal input from the EZW-RT10 (SA-WSF500 only)
69 to 72 - - Not used
73 CABLE DETECT I Connect detection signal input from the SYSTEM CONTROL connector (HCD-F200/F500)
74 SYS_WAKEUP I System wake up signal input from the SYSTEM CONTROL connector (HCD-F200/F500)
75 DRIVE_OCP (DIAG) I Shut down state input from the digital power amplifi er "L": shut down
76 S-AIR_ADC_SEL O Selection signal output terminal Not used
77 S-AIR_I2C_SDA I/O I2C Two-way data bus with the EZW-RT10 (SA-WSF500 only)
78 S-AIR_I2C_SCL I/O I2C data transfer clock signal input/output with the EZW-RT10 (SA-WSF500 only)
79 S-AIR_SRC_MUTE O Muting signal output to the ASYNC sample rate converter (SA-WSF500 only)
80 S-AIR_RST O Reset signal output to the ASYNC sample rate converter and EZW-RT10 (SA-WSF500 only)
81 S-AIR_DET I Connect detection signal input from the EZW-RT10 (SA-WSF500 only)
82 S-AIR_HPOUT O Selection signal output to the data selector (SA-WSF500 only)
83 to 86 - - Not used
87 SYS_RESET O System reset signal output to the SYSTEM CONTROL connector (HCD-F200/F500)
88 to 90 - - Not used
91 DEVICE O Device selection signal output terminal Not used
92 DEST I Setting terminal for the destination
93 MODEL I Setting terminal for the model
94, 95 - - Not used
96 AVSS - Ground terminal
97 - - Not used
98 VREF I Reference voltage (+3.3V) input terminal
99 AVCC - Power supply terminal (+3.3V)
100 DIR_HDOUT I Read data input from the digital audio interface receiver