To activate the muting function
Press MUTING.
The muting function will be canceled when
you do the following.
• Press MUTING again.
• Increase the volume.
•
Tum
off the receiver.
To avoid damaging your
speakers
Before you tum
offthe
receiver, be sure to tum
down the volume level.
Naming
inputs
You can enter a name
of
up to 8 characters for
inputs and display it on the receiver's display.
This
is
convenient for labeling the jacks with
the names
of
the connected components.
1 Press the input button to select
the input you want to create an
index name for.
You can also use INPUT SELECTOR on
the receiver.
2 Press AMP MENU.
"I-LEVEL" appears on the display.
3 Press
+,+
repeatedly to select
"4-SYSTEM".
4 Press 8
or.
to enter the
menu.
5 Press
+,+
to select "NAME IN".
6 Press 8
or.
to enter the
parameter.
The cursor flashes and you can select a
character.
7 Press
+,+
to select a character,
then press
+,.
to move the
cursor to the next position.
If you made a mistake
Press
.1+
until the character you want
to
change flashes, then press
+1+
to select
the correct character.
Tips
• You can select the character type as follows
by pressing
+/+.
Alphabet (upper case) --+
Numbers--+
Symbols
• To enter a blank space, press + without
selecting a character.
8 Press
8.
The name you entered
is
registered.
23
US
To Next Page
Loading...
