Settings
for
the
system
(SYSTEM
menu)
You can use the SYSTEM menu to customize
the settings
of
the receiver.
Select "4-SYSTEM"
in
the amplifier menus.
For details on adjusting the parameters, see
"Navigating through menus" (page 24) and
"Overview
of
the menus" (page 25).
SYSTEM menu parameters
• NAME
IN
(Naming inputs)
Lets you set the name
of
inputs. For details,
see "Naming inputs" (page 23).
• DIMMER (Brightness of the
display)
Lets you adjust the brightness
in
3 steps.
• 12V TRIG. (12V Trigger)
Lets you tum the receiver on/off
in
another
zone, or select various option for use
of
the
12V Trigger function.
• INPUT (for main zone only)
Lets you tum on the output
of
12V
triggers
when the preset input is selected.
When you select "INPUT", the setting
display which sets each input trigger to
ani
off appears. Press
+1+
to select the input,
then press
(B.
Press
+1+
again to select
"ON"
or "OFF", then press
(B.
•
ZONE
Lets you tum the output
of
12V triggers on
or off based on whether the selected zone is
turned on
or
off.
• CTRL
Lets you tum the output
of
12V triggers on
or off manually using the CIS command
of
the
IR
remote.
• OFF
Lets you tum
off
output
of
12V
triggers even
when the main receiver
is
turned on.
28
US
Tips
•
Even
when this receiver is in standby mode (press
1/6
on the remote to turned off this receiver), the
receiver in zone 2 remains turned on. To turn
off
all
receivers, press
1/6
and
AV
1/6
on
the
RM-
AAU056 remote at the same time
(SYSTEM
STANDBY).
• Only signals from components connected to the
analog input
jacks
are output through the
ZONE
2
OUT
jacks.
• When tuner is selected; the same type
of
radio
station
(FM/
AM) selected in the main zone is set in
zone 2. However, you can select the input
other
than tuner in zone 2.
• When the receiver in the main zone is turned off, or
an input source otherthan tuner
is
selected, you can
select a radio station from AM
or
FM
in
zone
2.
When the receiver in the main zone
or
zone 2
is
turned off, you can select a broadcast from
FM/
AM/XM/SIRIUS
in one zone in which the receiver
is turned on.
• RS232C (RS232C Control)
Lets you use this menu for the zone 2
operation.
• ON
The receiver can receive commands from the
RS232C port.
• OFF
The receiver does not receive commands
from the RS232C port.
To Next Page
Loading...
