TU.~i~I··.··!:~~~···.·~··.~tat:io,,'·direc.tIY
(DireCI.,:''funing)
..
.
: .-.--::-.-.:;---: .
Enter the frequency
of
a station directly by
using the numeric buttons.
1 Press TUNER repeatedly to
select the
FM
or AM band.
You can also use FM/AM on the receiver.
2 Press D.TUNING.
3 Press the numeric buttons to
enter the frequency.
Example
j:
FM j 02.50 MHz
Select 1 • 0 • 2 • 5
Example
2:
AM 1,350 kHz
Select 1 • 3 • 5 • 0
If
you have tuned in an AM station, adjust
the direction
of
the AM loop antenna
(aerial) for optimum reception.
4 Press ENTER or
e.
You can also use MEMORYIENTER on
the receiver.
If
you cannot tune
in
a station
Make sure you have entered the right
frequency.
If
not, repeat steps 2 to 4.
If
you
still cannot tune in a station, the frequency is
not used in your area.
30
US
Chaingiidgtbe
.AM:itllllilltl.lale
..
(Model of area code UC only)
You
can change the AM tuning scale to either
9 kHz or
10kHz
using the buttons on the
receiver.
1/6
FM/AM
1 Press
116
to turn off the
receiver.
2 While holding down FM/AM,
press
1/6.
3 Change the current AM tuning
scale to 9 kHz (or
10kHz).
To
reset the scale to
10kHz
(or 9 kHz),
repeat the procedure above.
Note
All preset stations will be erased when you change
the tuning scale.
To Next Page
Loading...
