56
US
1 Select “Listen” from the home
menu, then press .
2 Select “FM/AM,” then press .
The FM/AM screen appears.
3 Select the band switch.
4 Press V/v to select “FM” or
“AM,” then press .
1 Select the frequency indication
on the FM/AM screen.
2 Press V/v.
V scans from lower to higher frequency
stations and v for scanning higher to
lower.
The receiver stops scanning whenever a
station is received.
In case of poor FM stereo
reception
1
Tune in the station you want to listen to
using Auto Tuning, Direct Tuning, or
select the preset station you want
(page 57).
2 Press INFO/OPTIONS.
The options menu appears.
Note
You can set “FM Mode” in the options menu
when the frequency indication is selected, or
when called for in another situation.
3 Select “FM Mode,” then press .
4 Select “Monaural,” then press .
Enter the frequency of a station directly by
using the numeric buttons on the remote
control.
1 Press SHIFT, then press
D.TUNING on the FM/AM
screen.
2 Press the numeric buttons to
enter the frequency, then press
.
Example 1: FM 102.50 MHz
Select 1 b 0 b 2 b 5
Example 2: AM 1,350 kHz
Select 1 b 3 b 5 b 0
Tips
• Adjust the direction of the AM loop antenna
(aerial) for optimum reception upon tuning to an
AM station.
Toggling between FM and AM
radio
Tuning to a station
automatically (Auto Tuning)
V/v/B/b,
HOME
INFO/
OPTIONS
D.TUNING
Numeric
buttons
SHIFT
?/1
RETURN/
EXIT O
Tuning into a station directly
(Direct Tuning)
To Next Page
Loading...
