18
STR-DA5200ES
RM-AAU009
This remote is only for zone 2/zone 3
operations. You cannot control the main
receiver directly with this remote.
Operating the main receiver from
zone 2
Name Function
A ?/1 (on/
standby)
Press to turn a receiver in zone 2
or zone 3 on or off.
B Command
mode
buttons
Press to select the command
mode of the remote.
C Input
buttons
Press one of the buttons to
select the component you want
to use. When you press any of
the input buttons, the receiver
turns on. The buttons are
factory assigned to control Sony
components as follows.
D MUTING Press to mute the sound.
E MASTER
VOL +/–
Press to adjust the volume level
for multi zone output.
F RM SET UP Press to change the category of
the buttons.
G RM SET UP
indicator
Lights up when data is being
sent or when the remote button
assignment is being preset.
*The setting cannot be changed.
Button Assigned Sony
component
VIDEO 1 VCR (VTR mode 3)
VIDEO 2 VCR (VTR mode 1)
VIDEO 3 VCR (VTR mode 2)
DVDDVD player
TV/SAT TV tuner
TAPE/
CD-R
Tape deck B
MD/DAT MD deck
SA-CD/CD Super Audio CD/CD
player
TUNER* Built-in tuner
SOURCE The current input
selected for the main
receiver
Operating the components
connected to the main receiver
from zone 2 or zone 3
*The function of these buttons switches
automatically each time you press the input
buttons C. The above explanation is intended to
serve as an example only. Therefore, depending
on the component, the above operation may not
be possible or may operate differently than
described.
Name Function
H Operation
buttons*
The following table describes
the function of the buttons.
I CH/
PRESET/
D.SKIP
+/–*
Press repeatedly to select a
preset station or channel. When
using a multi-disc changer,
press to skip a disc.
Button(s) Function
N Starts play. (Starts play
on the front side of the
cassette.)
n Starts play on the
reverse side of the
cassette.
X Pauses play or
recording, and starts
recording when the
component is in
recording standby.
x Stops play.
./> Skips tracks.
m/M Go backward/forward.