Operations Using the Remote RM-PP413
masterpage:Right
lename[E:\SEM_Janet\Revision2_STR-
B795\J9040000_2148931122DB795CEL\2148931122\GB08REM_STR-DB795-CEL.fm]
49
GB
model name1[STR-DB795]
[2-148-931-12(2)]
Notes
• Some functions explained in this section may not
work depending on the model.
• The above explanation is intended to serve as an
example only. Therefore, depending on the
component the above operation may not be possible
or may operate differently than described.
• To activate the buttons with orange printing, press
ALT first before pressing the buttons.
• The SOURCE button on the remote is not available
for receiver operation.
Set the remote command mode using the
RM SET UP button and the remote command
mode buttons.
Selecting the command mode
You can switch the command mode (AV1 and
AV2) of the remote. If the command mode of the
receiver and the remote is different, you cannot
use the remote to operate the receiver.
Press AV1 (or AV2) while holding down
RM SET UP.
The indicator flashes once (twice for AV2) ,
then the command mode switches.
To check the command mode of
the remote
Press RM SET UP. You can check the remote by
the indicator.
To reset the remote to factory
settings
Press ?/1, AV ?/1 and MASTER VOL – at
the same time.
The indicator flashes 3 times, then goes off.
Note
If the command mode of the receiver and the remote is
different, you cannot use the remote to operate the
receiver. To change the command mode of the
receiver, see page 55.
Selecting the command
mode of the remote
Mode Indicator flashes
AV1 once
AV2 twice
To Next Page
Loading...
Need help?
General
Weight and Dimensions
