UsingtheSleepTimer
You call set the receiver to turn off
automatically at a specified time.
Press SLEEP repeatedly while the
power is on.
Each time you press the button, tile display
changes cyclically as follows:
2-004)0 --+ 1-30-00 --+ 1-00-00 --+ 0-30-00
--+ OFF
When sleep timer is activated, the display
dims.
Note
]f you press any buttons on the remote or receiver
afler Ihe display dims, Ihe display brightens up.
After a while, the display dims again if ito bllllOi] is _'
pressed.
Tip
To check the remaining time beh_re the receiver
turns ofl, press SLEEP. The rmnaining lime appears
on the display. If you press SLEEP again, the sleep
timer will be canceled.
Recordingusingthe
receiver
4
Prepare the playback
component for playing.
For example, insertthe video tape you
want to copy into the VCR.
Prepare the recording
component.
Insert a bhmk video tape, etc. into tile
recording component (VIDEO 1) l\_r
recording.
Start recording on the
recording component, then
start playback on the playback
component.
Note
Some stmrces contain copy guards to prevmlt
recording. In this case, you may not be able to record
lhom the source.
60 G8
To Next Page
