40
GB
You can enter the frequency of a station
directly by using the numeric buttons.
1 Press D.TUNING.
2 Press the numeric buttons to enter
the frequency, then press .
Example 1: FM 102.50 MHz
Select 1 b 0 b 2 b 5 (b 0*)
Example 2: AM 1,350 kHz
Select 1 b 3 b 5 b 0
* Press 0 for Europe and Australia models
only.
Adjust the direction of the AM loop antenna
(aerial) for optimum reception upon tuning
to an AM station.
If you cannot tune to a
station
“– – – .– – MHz” or “– – – – kHz” appears
and then the screen returns to the current
frequency.
Make sure you have entered the right
frequency. If not, repeat steps 1 to 3. If you
still cannot tune to a station, the frequency
may not be in use in your area.
(USA and Canada models only)
You can change the AM tuning scale to
either 9 kHz or 10 kHz using the buttons on
the receiver.
1 Press ?/1 to turn off the receiver.
2 While holding down TUNING
MODE, press ?/1 on the receiver.
The current AM tuning scale is
changed to 9 kHz (or 10 kHz).
To reset the scale to 10 kHz (or 9 kHz),
repeat the procedure above.
• Depending on the settings, the receiver may take
some time to change the AM tuning scale.
• All preset stations will be erased when you
change the tuning scale.
Tuning to a station
directly (Direct Tuning)
Tip
Changing the AM tuning
scale
Notes
?/1
TUNING MODE
To Next Page
Loading...
