Speakers connected to both the SPEAKERS FRONT A and SPEAKERS SURROUND
BACK/BI-AMP/FRONT HIGH/FRONT B terminals (parallel connection).
(None):
[SPK OFF] appears on the display panel. No audio signals are output from any speaker
terminals.
Note
This setting is not available when headphones are connected.
When you press SPEAKERS on the receiver, the [Bluetooth Mode] changes to [Receiver]
automatically.
[46] Preparation Performing Auto Calibration
5. Performing Auto Calibration
You can perform automatic calibration from your listening position.
Note
If the measurement fails, follow the message, then select [Retry]. For details on the error code and
warning message, see “List of messages after Auto Calibration measurements
.”
This setting is not available when headphones are connected.
Hint
The Auto Calibration function will be canceled if you perform the following during the measurement
process:
Press .
Press the input buttons on the remote control or turn INPUT SELECTOR on the receiver.
Press HOME, AMP MENU or
on the remote control.
Press SPEAKERS on the receiver.
Change the volume level.
Connect headphones.
To select [SPB] or [SPA+B], set the assignment for the SPEAKERS SURROUND BACK/BI-AMP/FRONT
HIGH/FRONT B terminals to [Front B] by using [Surround Back Speaker Assign] in the [Speaker Settings] menu.
*
Select [Setup] - [Speaker Settings] from the home menu.
1
Select [Auto Calibration].
2
Follow the instructions on the TV screen, then press
to select [Start].
The measurement starts in 5 seconds.
The measurement process will take approximately 30 seconds with a test tone.
When the measurement ends, a beep sounds and the screen switches.
3
Select the item you want.
Save: Saves the measurement results and exits the setting process.
Retry: Performs the Auto Calibration again.
Discard: Exits the setting process without saving the measurement results.
For details on the measurement results, see “6. Checking
Auto Calibration results.”
4
Save the measurement results.
Select [Save] in step 4.
5
To Next Page
Loading...
