Sony STR-ZA2000ES - Connecting Speakers

1. Select [Speaker Pattern] in the Speaker Setup menu, then select a speaker pattern
that does not have surround back and front high speakers.
2. Set [SB Speaker Assign] in the Speaker Setup menu to [Front B].
You can select the front speaker system you want by using the SPEAKERS button on the
receiver.
You can connect the front speakers to this terminal using a bi-amplifier connection. In this
case, set [SB Speaker Assign] in the Speaker Setup menu to [Bi-Amp].
Note
After you have installed and connected your speakers, be sure to select the speaker
pattern you want using [Speaker Pattern] in the Speaker Setup menu.
[10] Preparation
Installing and connecting speakers
Connecting speakers (for STR-ZA2000ES/STR-
ZA1000ES)
Connect each speaker as illustrated below.
Be sure to disconnect the AC power cord (mains lead) before connecting cables.
For details on how to connect speaker cables to the receiver, see “How to connect speaker
cables.”