Sony STR-ZA2000ES - Page 84

This function works only when the sound field is set to [HD-D.C.S.].
[84] Adjusting Settings Audio Setup
Enjoying more natural sound with speakers installed in
the ceiling (In-Ceiling Speaker Mode)
Set whether or not to use in-ceiling speaker mode with the current input.
In a setup where the front and center speakers are installed in the ceiling, lowering the audio
output position to the screen height allows you to enjoy a more natural experience.
1. Select [Setup] - [Audio Setup] from the home menu.
2. Select [In-Ceiling Speaker Mode].
3. Select [On].
Note
This function does not work in the following cases:
[2ch Analog Direct] is selected.
A speaker pattern with the front high speakers is selected.
[Pro Logic II], [Pro Logic IIx] or [Neo:6] is selected.
[Pure Direct] is set to [On].
This function may not work depending on the audio format.
The receiver may play signals at a lower sampling frequency than the actual sampling
frequency of the input signals depending on the audio format.
Hint
You can also switch this function on/off for each input on the Input Setup screen.
You can also select [In-Ceiling Speaker Mode] in [Sound Effects] from the home menu.
You can also switch the function on/off by pressing IN-CEILING SP on the remote control
or the receiver.
To obtain optimal effects in the listening environment, configure the [Ceiling Speaker
Height] setting and perform Auto Calibration.
[85] Adjusting Settings
Audio Setup
Enjoying high-fidelity sound (Pure Direct)