5-3
5-1-2. Adjustments 2
Perform the following adjustments for each of the following
five input signals.
Set the settings required for each signal at the INPUT CON-
FIGURATION of the SETUP menu. When inputting the com-
posite signal, insert the NTSC input adapter BKM-24N
(NTSC)/25P (PAL) into the empty slot of the unit.
1. COMPONENT SMPTE/EBU-N10
100% color bar signal
All white peak 700 mV
B–Y 700 mV p-p
R–Y 700 mV p-p
100 IRE all white signal
All white peak 700 mV
20 IRE all white signal
All white peak 140 mV
2. COMPONENT BETACAM SETUP 7.5
75% color bar signal
All white peak 714.29 mV
B–Y 700 mV p-p
R–Y 700 mV p-p
100 IRE all white signal
All white peak 714.29 mV
20 IRE all white signal
All white peak 142.86 mV
3. COMPONENT BETACAM SETUP 0
75% color bar signal
All white peak 714 mV
4. COMPOSITE NTSC SETUP 7.5
100% color bar signal
All white peak 714 mV
5. COMPOSITE NTSC SETUP 0
100% color bar signal
All white peak 714 mV
Set as follows at the INPUT CONFIGURATION menu of
the SETUP menu.
FORMAT .............Set according to the input signal
SLOT NO.............When component signal is input: 6
When composite signal is input: Slot
no. when BKM-24N (NTSC)/25P
(PAL) is mounted.
SYNC MODE ......INT
To Next Page
Loading...
