Need help?Do you have a question about the Sony Trinitron BVM-A14F5M and is the answer not in the manual?
Provides visual overview and identifies physical locations of boards within the unit.
Detailed steps for disassembling the unit to access internal components and boards.
Explains the process of programming PLDs or ROMs using the e-Production method.
Details the setup adjustments required after replacing the CRT unit.
Step-by-step instructions for adjusting the monitor's focus.
Procedures for configuring and performing DY position adjustments.
Instructions for adjusting horizontal blanking in UNDER SCAN modes.
Procedures for adjusting screen linearity across various parameters.
Procedures for checking and adjusting the high voltage regulator RV501.
Procedure to check the beam current protector circuit and its operation.
Details the necessary adjustments for the BK board, including control settings.
Contains warnings and information regarding safety-related components and parts standardization.
Provides exploded views of the unit with part numbers and descriptions.
A detailed list of electrical components with their part numbers and descriptions.
The first part of the overall block diagram of the BVM-A14 system.
Block diagram for the BK board, part 1 of 5.
Block diagram for the EA board, part 1 of 2.
Schematic diagram of the main unit's frame and chassis components.
Schematic diagram for the BC board, part 1 of 7.
Schematic diagram for the BK board, part 1 of 15.
Schematic diagram for the EA board, part 1 of 2.
Schematic diagram for the G board, part 1 of 2.
Schematic diagram for the HC board, part 1 of 4.
Schematic diagram for the PA board.
Schematic diagram for the PC board.
Board layout diagram for the BC board.
Board layout diagram for the BK board.
Board layout diagram for the CA board.
Board layout diagram for the EA board.
Board layout diagram for the G board.
Board layout diagram for the HA section.
Board layout diagram for the HB section.
Board layout diagram for the HC section.
Board layout diagram for the HD section.
Procedure for measuring AC leakage current to ensure safety compliance.
To Next Page
General