3
Precautions
Installation
When connecting the Artisan
TM
Color Reference System, be sure that the Artisan
TM
Signal Cable (which connects the GDM-
C520 display to your computer) is properly connected, according to page 12 of this manual.
The Universal Serial Bus (USB) connections in this system (on the Artisan
TM
Sensor and on the Artisan
TM
Signal Cable) can
be connected to a USB hub instead of directly into the computer. However, there are two limitations to this feature:
❑ The Artisan
TM
Signal Cable must be connected to a self-powered USB hub.
❑ The Artisan
TM
Sensor can be connected to either a self-powered or a bus-powered hub.
Note: The Apple keyboard is considered a bus-powered hub.
Calibration
The suction cups used in the Artisan
TM
Sensor, if pressed forcefully against the display screen, may scratch the screen glass.
When beginning calibration, press the sensor against the screen firmly, exerting even pressure in order to attach all suction
cups.
Remove the sensor by peeling one edge of the sensor off first, and then continuing the peeling motion until all suction cups
have been dislodged.
To Next Page
Loading...
