'VM-6041OM I
SECTION 1
GENERAL
1-1. FEATURES
-J:f~UiColOr"sistemS'l.%Vai18ble
The monitor can display PAL, SECAM, NTSCJse and
NTSC4 43• signals. The appropriate color system is selected
automatically.
* A signal ot NTSC• •J 1s used for playing back NTSC recorded
v1deocassettesw1th avideotaperecorder/playerespec1ally
des1gnedforusewithth1ssysrem.
!]3fiie only p(cfur~
The picture can be displayed in blue and black only. This
facilitates hue adjustment and the observation of video
noise.
Analog RGB or component (Y, R"Y, and B-Y) signals from
video equipment can be input through these connectors.
The
built-in beam current feedback circuit assures stable
white balance.
When NTSC video signals are received, a comb filter
activates to increase the resolution, resulting In
line picture
detail without color spill or color noise.
-4-
Automatic terminal:iOn of BNC co.nnectors ·
The rear BNC input connectors are internally terminated
75 ohms
when nothing Is connected to the output connector
(VIDEO OUT). However, this impedance limit is automati-
cally removed when a cable is plugged into the output
connector, and the signal Is looped-through as 111s.
EIA standard 19~inch rack mounting
By using an MB-507 mounting bracket (not supplied), the
monitor can be mounted in an EIA standard 19-inch rack.
For
details on mounting, see the instruction manual of the
MB-507.
To Next Page
Loading...
