Features and Specifications DLM-E 3kW & 4kW Series Power Supplies
1-2 M362000-01 Rev E
• High input AC power factor, 0.98 typical, with single–phase input.
• Front panel controls for Enable/Standby and Local/Remote modes of operation.
• Simultaneous digital display of both DC voltage and current.
• Front panel preview switch allows voltage, current, and OVP to be preset from local
or remote control.
• Local lockout feature with front panel indicator is selectable by rear panel switch.
• No internal jumpers or switches to change programming and monitor ranges.
• Current sharing parallel port and simple cable interface allows several units to be
connected in parallel to provide increased power and current.
• Voltage and current controls with ten turn potentiometers permit high resolution
setting of the output voltage and current from zero to the rated output.
• Automatic mode crossover into current or voltage mode, with mode indication.
• High frequency switching technology allows high power density, providing
increased power output in a small package.
• Remote sensing to compensate for losses in power leads.
• Fast response time for programming or load changes.
• Adjustable Over–Voltage Protection (OVP) with preview
• External DC shutdown (positive or negative logic selectable).
• Remote voltage, current, and OVP programming with selectable programming
range.
• External indicator signals for remote monitoring of OVP status, local/remote
programming status, thermal shutdown, and output voltage and current.
• Installation Category III, Pollution degree 2.
For Indoor Use Only.
• CE Approvals to EN61010-1 1993
CE Mark tested to: EN61326
EN61010-1:1993
(FCC) 47 CFR Part 15, Subpart B, 107 (e), Class A, 109 (g) Class A
• Optional IEEE-488 interface for complete remote programming and readback
capability with M9E option.
• M85 slave option allows programming of up to 31 power supplies from one GPIB
address.
To Next Page
Loading...
