SoundGear Phantom - Device Insertion and Removal; How to Insert and Remove Devices

Use and Care | 25 24 | Charging
3.2 Charger On-Board Battery LEDs
• When charger is plugged in and fully
charged = 4 solid LEDs will appear
• When charging without the cord the LEDs
will turn off after 10 seconds
• To refresh LEDs, remove a SoundGear
device from the charging post for
3 seconds and then replace it in the
charger (refresh lasts 10 seconds only –
then LEDs will turn off again)
• 4 Solid > 75%
• 3 Solid < 75%
• 2 Solid < 50%
• 1 Solid < 25%
• 1 Blinking = Charge Low
• While charging the on-board battery with
the provided cord, the 4 LEDs will be:
• Glowing while charging
4.1 Insertion and Removal
To insert the SoundGear
device:
1. Hold the SoundGear
device with your thumb
and forefinger on the
outer edges of the case.
2. Tilt your hand slightly
forward and gently
insert the canal tip
of the SoundGear
device into your ear
canal and rotate the
SoundGear device
backward. Softly press
the SoundGear device into place with
your fingertip.
To remove the SoundGear device:
Grasp the SoundGear device with your thumb
and forefinger; gently rotate it as you pull
outward.
1
2